Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
WARNING
Hazardous voltage.
Can shock, burn, or cause
death.
Ground pump before
connecting to power
supply. Disconnect power
before working on pump,
motor or tank.
Wire motor for correct
voltage. See "Electrical"
section of this manual
and motor nameplate.
Ground motor before
connecting to power
supply.
Meet National Electrical
Code, Canadian
Electrical Code, and
local codes for all
wiring.
Follow wiring
instructions in this
manual when
connecting motor to
power lines.
Electrical Safety
Risk of electrical shock. Can shock, burn or
kill. Before installing or servicing your pump, be certain
the pump power source is disconnected. If in doubt,
consult a qualified electrician.
Make sure the line voltage and frequency of the
electrical power supply agrees with the motor wiring. If
motor is dual voltage, be sure it is set correctly for your
power supply.
Do not use extension cords.
Do not use this pump in or near a swimming pool.
General Safety
Risk of burns. Do not touch an operating
motor. Motors are designed to operate at high
temperatures. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down
before handling.
Do not allow pump or any system component to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Risk of explosion. Pump body may explode
if used as a booster pump unless relief valve capable of
passing full pump flow at 75 psi is installed.
2
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.
Publicité
Table des Matières
