Operator Specifi Cations; General Specifications - Aprimatic RAIDER Instructions Pour L'installation

2.1 USE AND FIELD OF APPLICATION
The RAIDER electro-mechanical operator is designed to move double wing gates or single wing gates automatically.
It should be used on residential gates only and is designed for gates which are not open/closed more than 50 times daily.
Information
• Only use the product for the permitted uses specifi ed. Do not use the product for purposes other than
those specifi ed.
• Do not tamper with or modify the product.
• The product should only be installed using APRIMATIC material.
Caution
The operator does not form part of the support or safety system of the gate. The gate should already have
adequate safety and support features.
2.2

GENERAL SPECIFICATIONS

- The RAIDER operator is non-reversible and will therefore keep gates with wings up to 1.8 metres long in the open or
closed position without the need for an electric locking device.
Note: For longer wings (up to a maximum of 3 metres) you should use an electric locking device.
WARNING: The motor is non-reversing. This feature prevents intrusion on any size gate.
- The emergency release will enable manual control of the gate in the event of a power failure.
The emergency release is easily accessible on the lower part of the operator. It is guaranteed to work and is easy to use
(see par. 8.2).
- Anti-crushing safety is set by adjusting the Aprimatic controller model CCR24 or any similar Aprimatic controller
model fi tted.
IMPORTANT! DO NOT use other electronic equipment Aprimatic S.p.A. declines all liability for damages caused by failure
to follow these instructions.
2.3 TECHNICAL DATA (Table 1)
!
Warning
The noise level of the operator on release from the
wing and the pillar, is within the maximum limits
established by EU regulations.
2.4 SPACE REQUIREMENTS (Fig.3)
Fig. 3
168
55
RAIDER
Power supply
Motor supply voltage
Power absorption
MAX thrust force
MAX linear speed
Operating temperature
MAX stroke
909
871
C = 300
- 21 -
Operator specifi cations
474
Tab.1
230 V a.c. - 50 Hz
+6% -10%
24 V d.c.
70 W
1500 N
13 mm/sec.
-20˚/+55˚C
300 mm