Sony NSR-500 Série Manuel D'installation page 37

4
Configure each item, and click [OK].
Device Model
Select the model name for the camera.
Normally, select "Auto Connect."
When setting this manually, select the
model name.
Name
Enter the name to assign to the camera
to be added. It can be up to 32
characters and consist of alphanumeric
characters and some symbols (periods
(.), hyphens (-), underscores (_)).
IP Address
Enter the IP address or the host name
for the camera.
Port
Enter the port number on the camera
side for when connecting with the
camera. The default setting is "80."
Proxy
Set this when the camera will be
accessed via a proxy server.
Enable
Select the check box, and configure
the following items.
IP Address
Enter the IP address or the host
name for the proxy server.
Port
Enter the port number for the proxy
server.
User Name
Enter the user name for connecting to
the device. It can be up to 32 characters
and consist of alphanumeric characters
and some symbols (periods (.),
hyphens (-), underscores (_)).
Password
Enter the password for connecting to
the device. It can be up to 32 characters
and consist of alphanumeric characters
and some symbols (periods (.),
hyphens (-), underscores (_)).
When registering a camera server
(SNT series, etc.):
The following dialog box appears.
Select the channel to use, and click [OK].
Notes
• A check is performed to determine
whether the maximum number of
registered cameras has been exceeded
during processing. If the maximum
number has been exceeded, a warning
message appears to notify you and
processing stops.
• If registration for a camera fails, start
your Web browser and connect directly
to the camera to confirm that images
from the camera are displayed. In
addition, use the IP address you entered
in the Web browser for the camera's IP
address.
The device is registered to NSR, and is
added to the list.
Step 3: Settings 37