Configuring Initial Settings With Setup Wizard - Sony NSR-500 Série Manuel D'installation

Also, if you press the power switch, and
then press the power switch again while the
POWER LED is blinking green (for up to 3
seconds), the unit begins the shutdown
process and then the power turns off after
several minutes.
Note
If the unit does not turn off after a while,
press and hold the power switch on the front
of the unit (for about 5 seconds) to force the
power to turn off.
Configuring Initial Settings
with Setup Wizard
This section explains the general flow of the
Setup Wizard. For further details on
settings, refer to "Changing Initial Settings
with the Setup Menu" in the User's Guide
(PDF).
The Setup Wizard starts automatically
when you turn on the unit for the first time.
You can configure the same settings
afterward by accessing the logon screen, the
Administration Menu, and then the Setup
Menu.
For details, refer to "To access the Setup
Menu from the logon screen" (page 28).
When you turn on the unit, the Setup
Wizard starts after the following screen
appears.
r
Click [Next].
r
Read the user license agreement carefully,
click [Accept], and then click [Next].
r
Select a display language, and click [Next].
Step 3: Settings 25