Electrical Safety - EUROM Brosse de désherbage Mode D'emploi

 When using the device, always wear sturdy shoes or boots to protect your feet and long
trousers to protect your legs.
 Do not expose the device to rain or submerge in water or any other liquid, and avoid it getting
wet.
 Check the device before use. If you notice any damage, do not use it!
 Damage or any other defects must be repaired by a competent mechanic.
 Never use the device without the protective cover or with a badly fitting cover or a damaged,
broken or worn cover.
 Do not use the device if the electric cable or extension cable is damaged or worn. Check
before use!
 If you damage the electric or extension cable during use of the device, remove the plug from
the socket immediately. Do not touch the cable until the power supply has been
disconnected!
 Do not use the weed brush near children or animals.
 Only use the weed brush in daylight or in well-lit conditions.
 Check to ensure that the weed brush has been assembled according to instructions.
 If you assemble the weed brush, use the tools supplied to prevent damage to the device.
 Wear protective gloves when assembling the brush.
 Once you have assembled the device, leave it to tick-over in a safe environment for a while.
If the device vibrates a lot, if you see damage to the brush or if you see other faults,
switch the device off immediately and try to find the cause and solve it.
 Do not use any worn brushes.
 Do not use the device for removing wet weeds.
 Before you start work with the device, remove stones, sticks, wires and other objects from the
area you will be clearing.
 Only use the device in a vertical position, with the brush directed towards the ground. Never
switch the device on while it is in another position!
 Do not rush when using the device.
 Do not exert any pressure on the device.
 Always keep your hands and feet away from the brush.
 Avoid touching the brush.
 Ensure that the electric cable does not touch the brush.
 Before you set the device aside, always switch it off and wait until the brush has stopped
turning. Never try to manually stop the brush turning!
 Be aware that the brush will continue to rotate even after you have turned it off!
 Only use the brushes recommended by the manufacturer.
 Always remove the plug from the socket once you have finished with the device, when you
wish to carry out maintenance or if the device is not being used.
 After use, store the device in a safe place, outside the reach of children.

ELECTRICAL SAFETY

 Before use, always check to ensure that the socket you wish to use provides the Voltage and
Hertz detailed on the weed brush's specification plate.
 Preferably connect the weed brush to an electrical group that is protected by an earth
leakage circuit breaker of max. 30 mA.
 Only use the following types of extension lead: H05VV-F, H05RN-F en H05RR-F.
17