EUROM Brosse de désherbage Mode D'emploi page 18

DESCRIPTION refer to drawing A
Your weed brush has been designed to remove weeds from between tiles and on patios.
ASSEMBLY
Assembly and adjustment of the steering handle (fig. A)

Mount the protective cover (4) on the device, as shown in drawing A.

Attach the steering handle to the shank using both knobs (9).
The steering handle can be adjusted as follows to acquire a proper balance:

Unscrew both knobs (9)

Adjust the handle to the required height.

Carefully tighten the knobs once more.
Assembly of the telescopic tube (fig. A)

Turn open the locking ring of the compression fitting (11) and slide it back over the cable
and the bottom telescopic tube (5).

Now insert the bottom telescopic tube (5) into the inner section of the compression fitting.
Attention: there is a lug inside the compression fitting, there is a groove in the bottom
telescopic tube. The lug must engage with the groove!

Slide the telescopic tube into the compression fitting until the lug passes a stop in the
groove. Now, the telescopic tube can no longer be slid out of the compression fitting.

Determine your desired length of the weed brush by sliding the telescopic tube in and out.
When you have found the right length, slide the locking ring over the compression fitting
again and tighten both sections again firmly.

You can adjust the length by loosening the locking ring, sliding the telescopic tube and
tightening the locking ring once more.

Check before use that the tube is properly fastened!
7 On/off switch
8 Unlocking
9 Main handle
10 Steering handle
11 Telescopic tube
12 Protective cover
7 Brush
8 Wheel
9 Knob
10 Screw
11 Compression fitting with locking
ring
18