EUROM Brosse de désherbage Mode D'emploi page 19

Assembly of the protective cover (fig. B)
 Mount the protective cover (6) on the device, as shown in drawing
B.
 Secure the protective cover with the screws (12).
 Replace the cover when it gets worn.
Wheel assembly (fig. C)
 Put the wheel axle (8) into the assembly hole (13) made for this
purpose.
 Push the axle firmly into place.
Brush assembly (fig. D)
 The hard brush supplied is suitable for regular and
stubborn weeds.
 Two brushes are supplied as standard.
 A worn brush must be replaced immediately.
Before securing or changing a brush,
always pull the plug out of the socket!
Wear protective gloves when assembling the
The holder (16) to which the motor shaft is attached sticks out of the device. Check that the
copper coloured compression bush is in the holder (or insert it). The hexagonal nut is now
placed over the holder and the collar. Now insert the brush shaft through the back of the nut as
far as possible into the collar. Finally, firmly tighten the nut (17) using both spanners (14 & 15).
To change the brush, loosen the nut once more and remove the worn brush. Before placing a
new brush, check that the compression bush is in the holder!
USER INSTRUCTIONS
Before use:
 Check that the steering handle, the wheel, the brush and the closure on the telescopic tube
are secure and adjusted correctly.
 Check that the socket you are using provides the correct voltage (see specification plate on
weed brush).
 Connect the weed brush to a suitable extension cable and hook the cable behind the clamp
(see fig. A).
 Hold the device with both hands (one hand on each handle) and check that the underside of
the device is flat and horizontal.
brush.
19