EUROM Brosse de désherbage Mode D'emploi page 21

SAFETY INSTRUCTIONS
When you are using electrical devices, please read the following safety instructions to avoid
electric shocks, injury or burns. Read the following carefully before using the device.
1. Keep the working area clean. Too many obstacles could lead to accidents and injuries.
2. Be aware of your surroundings. Electrical devices should not be used in the rain or in
damp conditions or in the vicinity of flammable substances or gases. Make sure you have
sufficient light.
3. Keep children and visitors out of the vicinity of the working area. They should not touch
the device or the extension cable!
4. Adapt your clothing and hairstyle to your activities and do not wear loose clothing or
hair, long chains or shawls when using devices with moving parts. Protective gloves and
shoes and optionally goggles, ear mufflers and a dust mask are also recommended.
5. Use the appropriate tools and do not use the device for tasks for which it is not designed.
Do not make any changes to the device. Inappropriate use and making changes to the
device will invalidate the warranty and release the supplier of any liability!
6. Always put the plug into the socket and then switch the device on in order to avoid
unintended operation.
7. Make sure that you stand firm and do not overstretch yourself to reach an awkward spot
with the device.
8. Never force the device; it works best and most safely if used in the appropriate manner.
9. Always be alert and use your common sense when working. Do not use the device when
you are tired.
10. Be careful with the electric cable. Do not pull it, over-run it or trip over it. Keep the cable
away from heat, oil and sharp edges.
11. Protect yourself from electric shocks and prevent bodily contact with earthed surfaces
such as pipes, radiators, etc.
12. Clear tools away immediately after use, to a dry, high or enclosed space out of the reach
of children.
13. Treat tools with care. Keep them clean and in good condition and replace any worn parts
promptly. Check the device and the cable regularly and allow competent persons to carry out
any maintenance. Never use the device if a part is damaged.
14. Always remove the plug from the socket when the unit is not in use.
CE STATEMENT
The undersigned Euromac bv., Kokosstraat 20, 8281 JC Genemuiden hereby declares that
the below product electric weed brush known under the brand name EUROM complies with
the European Directives LV Directive 2006/95/EU and EMC Directive 2004/108/EU and
conforms with the following requirements:
EN 60335-1:2012
EN 62233 :2008
EN 1083-2 :1997
EN ISO 12100-2/A1 :2010
ZEK 01.4-08
Genemuiden, 21/08/2014
W.J. Bakker, gen. Dir.
EN 55014-1 /A2 :2011
EN 55014-2/A2 :2008
EN 61000-3-2/A2 :2009
EN 61000-3-3 :2008
21