Publicité
①
①
②
8
②
③
English
TO OPERATE MOUTHVENT
The Mouthvent is operated by simply pulling the vent control down to open,
pushing up to close. When the vent control is closed, air is directed up along the
interior surface of the shield to help prevent fogging, and when it is opened, air
is channeled back to further enhance the airflow around the month and nose to
help move hot moist air out faster.
TO REMOVE/REPLACE BREATH DEFLECTOR
To remove, grasp either side of the edge and pull upward and toward to
①
opposite end
.
To install, first insert the center of the deflector in the receiving slot and then
push in the sides working from the center outwards
NOTE :
If you do not use the deflector we recommend you to install Anti-mist
spacer (optional) in this place as it actually acts as an anti mist ducting device.
TO REMOVE SHIELD
First, unlatch the shield by pushing up the latch lever ①.
Using a large coin, so as to not damage the slot in the screw head, remove the
two screws from both of the shield pivot covers ②. Take care to keep track of
the screws once removed.
Remove the complete shield assembly (the pivot cover and base plate on both
sides will stay on the shied) ③.
②
.
Publicité
Chapitres
