Multiplex Mode (For Hls 528-2 And Hls 528-3 Only); Installation - HYDAC ELECTRONIC HLS 528 Notice D'utilisation

HLS 528
3.2

Multiplex mode (for HLS 528-2 and HLS 528-3 only)

The Add-on-menu allows to assign an individual address »01« to »10« to each sensor
connected via the Sync/Com-channel (Pin5). The sensors perform the ultrasonic
measurement sequentially from low to high address. Therefore any influence between the
sensors is rejected.
The address »00« is reserved to synchronisation mode and deactivates the multiplex
mode. (To use synchronised mode all sensors must be set to address »00«.)
3 Controls of the HLS 528
Fig. 2: Touch Control

4 Installation

■ Assemble the sensor at the installation location.
■ Plug in the connector cable to the M12x1 (5-pole) connector.
Pin Colour*
1 brown
3 blue
4 black
2 white
5 grey
Fig. 3: Pin assignment with view onto sensor plug and colour coding of the HYDAC connection
cable
* valid for HYDAC accessories ZBE 08-02 and ZBE 08-05.
Status 12.06.2014
HLS 528-2
+U
B
- U
B
D2
D1
Sync.
HYDAC ELECTRONIC GMBH
HLS 528-3
+U
B
- U
B
D
I / U
Sync.
Page 7
HLS 528-5
+U
B
- U
B
D2
I / U
D1
Part No. 669826 E