User Navigation; Operation - Hach 3700 Série Manuel D'utilisation De Base

To connect the sensor to a Model E33 electrodeless conductivity transmitter, refer to
Table 3.
Figure 9 Connect the sensor to the analyzer
Connector Terminal
TB3 5
TB3 6
TB3 7
TB3 8
Section 5 User navigation
Refer to the controller documentation for keypad description and navigation information.
Section 6 Operation

6.1 User navigation

Refer to the controller documentation for keypad description and navigation information.
6.2 Configure the sensor
Use the Configure menu of the sc controller to enter identification information for the sensor and to
change options for data handling and storage.
1. Push the MENU key and select Sensor Setup, [Select Sensor], Configure.
2. Select an option. Use the arrow keys to select an option.
Note: For the sc100 and sc200 controller, push and hold the UP or DOWN arrow keys to enter numbers,
characters or punctuation. Push the RIGHT arrow key to advance to the next space.
Option
EDIT NAME
8
SENSOR S/N
8
Not applicable to the sc100 controller
Table 3 Sensor wiring information
Wire
Blue
White
Red
Clear (inner shield)
Description
Changes the name that corresponds to the sensor on the top of the measure screen.
The name is limited to 10 characters in any combination of letters, numbers, spaces
or punctuation.
Allows the user to enter the serial number of the sensor, limited to 16 characters in
any combination of letters, numbers, spaces or punctuation.
Connector Terminal
TB3 9
TB3 10
TB2 1
Figure 9 and
Wire
Yellow
Green
Black (outer shield)
English 15