Terminal Diagram - Reflex EFHR Mode D'emploi

5.3.1

Terminal diagram

Note!
• The cables of connection lines "1" and "2" are labelled with numbered terminals.
• The circuit diagram for the electrical connection is located on the inside of the cap.
Through appropriate reconnection of the connection lines in the heating circuits, it is possible to set three different heating outputs for the devices. The
devices are each supplied with maximum heating output.
Design: EFHR 4.0 KW / EFHR 6.0 KW / EFHR 8.0 KW / EFHR 10.0 KW.
Heating circuit 3
• Pre-wired
• Connection 400 V 3/PE AC
1 Connecting line 1
2 Connecting line 2
Water heater
3
Type: EFHR 4.0 KW
Heating circuit:
Capacity KW:
2.0
2.7
3.0
4.0
5.0
5.5
6.0
6.7
8.0
10.0
Heating circuit 4
•
•
EFHR 6.0 KW
3 4 5 3
X
X
X
X
EFHR electric flange heater — 18.10.2017
Reconnect wire 1
Connection 400 V 2/PE AC
4 Temperature controller
5 Temperature limiter
EFHR 8.0 KW
4 5 3
X
X
X
Installation
Heating circuit 5
• Disconnect wires 1 and 2
• Connection 400 V 2/PE AC
EFHR 10.0 KW
4 5 3 4
X
X
X
X
5
X
English — 9