Dexter 20VAG2-125.1 Mode D'emploi page 286

FR FR
2. SAFETY INSTRUCTIONS
ES ES
Safety Warnings Common for Grinding or Abrasive Cutting-Off
PT PT
Operations:
IT IT
A. This power tool is intended to function as a grinder or cut-off
tool. Read all safety warnings, instructions, illustrations and
EL EL
specifications provided with this power tool. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious
PL PL
injury.
RU RU
B. Operations such as grinding, sanding, wire brushing, polishing
or cutting-off are not recommended to be performed with this
KZ UA
power tool. Operations for which the power tool was not designed
may create a hazard and cause personal injury.
KZ UA
C. Do not use accessories which are not specifically designed
and recommended by the tool manufacturer. Just because the
RO RO
accessory can be attached to your power tool, it does not assure safe
operation.
BR BR
D. The rated speed of the accessory must be at least equal to the
EN
EN maximum speed marked on the power tool. Accessories running
faster than their rated speed can break and fly apart.
E. The outside diameter and the thickness of your accessory must
be within the capacity rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded or controlled.
F. Threaded mounting of accessories must match the grinder
spindle thread. For accessories mounted by flanges, the arbour
hole of the accessory must fit the locating diameter of the
flange. Accessories that do not match the mounting hardware of the
power tool will run out of balance, vibrate excessively and may cause
loss of control.
G. Do not use a damaged accessory. Before each use inspect
the accessory such as abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess wear, wire brush for
286