Further Safety Instructions For All Operations - Dexter 20VAG2-125.1 Mode D'emploi

FR FR
2. SAFETY INSTRUCTIONS
ES ES
M. Do not run the power tool while carrying it at your side.
PT PT
Accidental contact with the spinning accessory could snag your clothing,
IT IT
pulling the accessory into your body.
N. Regularly clean the power tool's air vents. The motor's fan will
EL EL
draw the dust inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
PL PL
O. Do not operate the power tool near flammable materials.
Sparks could ignite these materials.
RU RU
P. Do not use accessories that require liquid coolants. Using water
or other liquid coolants may result in electrocution or shock.
KZ UA

FURTHER SAFETY INSTRUCTIONS FOR ALL OPERATIONS

UA KZ
Kickback and Related Warnings
RO RO
Kickback is a sudden reaction to a pinched or snagged rotating wheel,
backing pad, brush or any other accessory. Pinching or snagging
BR BR
causes rapid stalling of the rotating accessory which in turn causes the
uncontrolled power tool to be forced in the direction opposite of the
EN
EN
accessory's rotation at the point of the binding.
For example, if an abrasive wheel is snagged or pinched by the workpiece,
the edge of the wheel that is entering into the pinch point can dig into the
surface of the material causing the wheel to climb out or kick out. The wheel
may either jump toward or away from the operator, depending on direction
of the wheel' s movement at the point of pinching. Abrasive wheels may also
break under these conditions.
Kickback is the result of power tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper precautions
as given below.
A. Maintain a firm grip on the power tool and position your
body and arm to allow you to resist kickback forces. Always
use auxiliary handle, if provided, for maximum control over
288