Information On Measuring Temperature - Medisana TM 750 Mode D'emploi

Masquer les pouces Voir aussi pour TM 750:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
GB
3 Operation
Setting the unit of measure, the time and the date:
When the thermometer is used for the first time or after a battery
change, the unit of measure, the time and the date must first be set.
If you want to return to the setting mode later on, press and hold
the SET-button
on.
After the self-test (where all the display symbols are shown in suc-
cession in the display
adjust the unit of measure (°C or °F) with the SET-button
the Memory-button
dure (SET-button
firm) for setting the year, month, day, hour and minute. After the last
press on the Memory-button
then the device will switch off automatically.

3.2 Information on measuring temperature

The sensor
all times in order to guarantee that the measurements are accurate.
Ear wax affects the measuring accuracy. If necessary, clean your
ear and the sensor tip of the thermometer before measuring in or-
der to avoid erroneous measurements.
Before taking a measurement on the forehead, clean the area and
remove any dirt, sweat or cosmetics before moving the sensor to
the measuring position as otherwise erroneous results could be
measured.
Do not measure your temperature immediately after eating,
training or bathing. Wait for half an hour.
Do not take successive measurements at intervals of less than one
minute. If you have to take your temperature at shorter intervals,
the results may fluctuate slightly.
The human body temperature fluctuates within a natural range.
There is no such thing as a standard body temperature.
Measure and record your body temperature on normal days. This
will allow you to detect a fever more easily.
In order to make an accurate measurement in the ear, the sensor
must be directed at the eardrum and be inserted far enough into
the ear canal.
24
7
for approx. 5 seconds, when device is switched
6
) two short beeps can be heard. Now you
9
to confirm the setting. Use the same proce-
7
to adjust a value and Memory-button
2
of the thermometer must be kept clean and intact at
9
the display
7
9
6
shows "OFF" and
g
g
. Press
to con-
g
g
g
g
g
g

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

76140

Table des Matières