Measuring Procedure - Medisana FTD Mode D'emploi

3. All symbols appear in the display at first. If the forehead tempera-
ture symbol
to the mode for taking a measurement in the ear. The change is
confirmed by a beep. The last temperature measured will appear
(see Fig.)
4. As soon as the symbol for measuring the temperature in the ear
appears in the display
the On/Scan button
5. The symbol for continuous temperature measurement
(see Fig.). Insert the sensor
still whilst measuring. After just a few seconds a short beep will
be heard and the display
temperature.
>
6. After the temperature has been measured, the device automatically
switches to the time and ambient temperature display mode (if the
time was programmed) or switches off.
3.4 Measuring the temperature at your forehead
1. To measure the body temperature at your forehead,
the sensor cover
2. Press the On/Scan button
3. All symbols appear in the display at first. If the symbol
for measuring the temperature in the ear
press the On/Scan button
taking a measurement in the ear. The change is confirmed by a
beep. The last temperature measured will appear (see Fig.)
4. As soon as the forehead temperature symbol
display , the device is ready for use (see Fig.)
5. Hold the device with the sensor
forehead and press the On/Scan button
button and drag the thermometer from the centre of your
forehead to the side, as far as your temple. When you reach this
position, release the button.
6. When temperature measurement is complete, you will hear a beep
and the body temperature will appear in the display
flashes, press the On/Scan button
, the device is ready for use (see Fig.) Press
again and hold it.
Stretch your ear canal by pulling your ear backwards and
upwards and carefully insert the sensor into the ear.
must be attached.
.

3 Measuring Procedure

in your ear. Keep the device
will show the measured body
>
flashes,
again to switch to the mode for
against the centre of your
. Hold down the On/Scan
again to switch
appears
>
appears in the
.
19
GB