3.5 Measuring the temperature of an object
1.
Switch on the thermometer by shortly pressing button for forehead
measurement mode
The device performs a self-test and emits two short beeps.
2.
Press and hold the set
for at least 3 seconds. The symbol for the surface temperature
measurement mode
3.
To begin the measurement, point the sensor
object (resp. of the liquid) at a distance of approx. 3 cm. Press the
button for forehead measurement mode
measurement mode
remove this first so that the reading is as accurate as possible.
4.
Release the button. After the measurement process is complete,
you will hear a beep and the object temperature will be displayed
in the display
The measurement result will automatically be saved. Again press
5.
and hold the set
at least 3 seconds to return to body temperature measurement
mode. After some seconds without pressing any button the device
will switch off automatically.
3.6 Recalling stored data
The MEDISANA Infrared thermometer TM 750 can store up to 30
results. You can call up your stored data with a short press of the
memory button
ment results appears in the display
3
or the button for ear measurement mode
7
& memory
i
appears in the display
4
. If the object has water, dust or dirt on it,
6
.
7
& memory
9
. Firstly, the average value of all stored measure-
9
buttons at the same time
6
2
at the middle of the
3
or the button for ear
9
buttons at the same time for
6
, e.g.:
3 Operation
4
.
GB
.
g
g
g
g
27