Amana NGD5800DW Instructions Pour L'installation page 21

2.
Move the door strike
Using a T25 screwdriver, remove the 2 screws securing
®
the door strike to the door frame of the dryer. Remove the
4 screws above and below the door strike and set aside for
later use. Rotate the strike 180° and attach to the opposite
side of dryer door frame, as shown.
3.
Remove inner door from outer door
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Latch
Using a T25
securing the latch plate and the 5 screws holding the hinge
assembly in place.
5.
Latch
Release tab
Using a T25
hinge assembly on the opposite sides from which they
were removed.
Remove hinge and latch
from inner door
screwdriver, remove the 3 TORX
®
Reinstall hinge and latch
on opposite sides
screwdriver, reinstall the latch plate and
®
Hinge
screws
®
Latch
21