Panasonic FZ-G1 Série Instructions D'utilisation page 11

6 Setup Windows
Select language and touch [Next].
Turn on the computer.
Follow the on-screen instructions.
l The computer restarts several times.
l After the computer is turned on, the screen remains black or unchanged for a while, but this is not a
malfunction. Wait for a moment until the Windows setup screen appears.
l Setup of Windows will take approximately
Go to the next step, confi rming each message on the display.
Follow the steps below.
l
A When "Enable sensors" is displayed, touch [Enable this sensor].
B When the [User Account Control] screen is displayed, touch [Yes].
C At the [Display Rotation Tool] confi rmation screen, touch [Yes].
The computer restarts automatically, and the setting is enabled.
l You can set the Wireless Network after the setup of Windows is complete.
If "Let's get connected" is displayed, select [Skip this step].
"Join a wireless network" screen may not appear.
CAUTION
l You can change the user name, password, image and security setting after setup of Windows.
l Remember your password. If you forget the password, you cannot use Windows. Creating a password reset
disk beforehand is recommended.
l Do not use the following words for user name: CON, PRN, AUX, CLOCK$, NUL, COM1 to COM9, LPT1 to
LPT9, LPT, &, space
In particular, if you create a user name (account name) that includes the "@" mark, a
l
password will be requested at the log-on screen, even if no password has been set. If you try to log on without
entering a password, "The user name or password is incorrect." may be displayed and you will not be able to
log on to Windows
(è OPERATING INSTRUCTIONS - Basic Guide).
7 Restart the computer
A Touch (Start).
B Touch (Power) - [Restart].
l A portion of the Panasonic PC Settings Utility functions will be enabled after the computer restarts.
8 Update the on-screen manual
A Connect to the internet.
istrator. For further information, refer to
B Update the on-screen manual.
Double-touch the [Panasonic PC Settings Utility] on the desktop screen, and then
touch [Support] - [Manual] - [Launch Manual Selector].
Double-touch [Manual Selector] on the desktop.
Follow the on-screen instructions.
9 Create a recovery disc
A recovery disc allows you to install OS and restore its factory default condition, in case, the recovery
partition of the fl ash memory is damaged. We recommend creating a recovery disc before you begin us-
ing the computer.
Refer to è OPERATING INSTRUCTIONS - Reference Manual "Recovery Disc Creation Utility" about
creating the disc.
5 minutes /
@.
Sign in /
OPERATING INSTRUCTIONS - Connect to a network.
20 minutes.
Log on to Windows as an admin-
11