Selecting The Spectrum Analyzer; Connecting Auxiliary Audio Equipment - Sony MEX-1HD Mode D'emploi

Selecting the spectrum
analyzer
The sound signal level is displayed on a spectrum
analyzer. You can select a display for 7 patterns
or the automatic display mode where all the
patterns appear.
SOURCE
1
Press (SOURCE) repeatedly to select a
source (CD, HDD, MEMORY STICK,
FM, AM, or AUX.)
2
Press (FUNCTION) repeatedly to
display the function menu "
3
Press (F1) (
select the desired S.A. pattern.
Each time you press the (F1), the item
changes as follows.
Off t Auto t 13Band Vertical t 19Band
Oblique t 3Band Horizontal t Smooth t
Wave t Desert t Heat Haze t Off
To cancel the S.A. display
Select "Mode Off" in step 3.
F1
FUNCTION
."
) repeatedly to
Connecting auxiliary audio
equipment
You can connect auxiliary audio equipment to
this unit with the AUX IN connector.
SOURCE
Selecting auxiliary equipment
Press (SOURCE) repeatedly to select
"AUX."
Note
If "AUX" is not displayed when you selecting the
source, set "AUX Skip" in "Setup" to "Off."
Adjusting the volume level
You can adjust the volume for each connected
audio equipment accordingly.
1
Press (MENU) while "AUX" is selected.
2
Rotate the R dial to select "Input
Level," then press the R dial.
3
Rotate the R dial to select the desired
volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
4
Press the R dial.
5
Press (MENU).
The normal display appears.
continue to next page t
MENU
R dial
53