Note: When selecting the Layer mode, the total number of voices that can play at
the same time is reduced, depending on the total number of oscillators used by the
selected sounds.
Note: You cannot select two sounds included under the same sound selection but-
ton.
Press one of the sound selection buttons in order to select the first sound. The LED
1
on the button you pressed will light. Use the SOUND BANK button to select a
sound in one of the other banks.
Press another sound selection button to select the second sound. The LED on the
2
button you pressed will light. Use the SOUND BANK button to select a sound in
one of the other banks.
Press both buttons at the same time to select the sounds. Both LEDs will light.
3
Note: Steps 1 and 2 are not required, if the right banks are already selected.
Returning to the Single mode.
sound selection button.
Adjusting the volume of sounds in Layer mode.
between the sounds in Layer mode, hold down the button of the sound whose level
you wish to decrease, and repeatedly press the button of the sound whose level you
wish to raise.
Note: This setting will be memorized even after turning the Layer mode off, but
will be lost when turning the instrument off. To save these settings, save them using
the Data Dump function (see "MIDI Data Dump" on page 35).
Choosing the reverb and the chorus
The EC150 has two effects: reverb and chorus. The reverb simulates the sound
reverberation in a room, while the chorus simulates a modulating effect that makes
the sounds richer. The last effect settings for a given sound will be remembered even
when selecting a different sound.
Note: Effect settings made in Single mode are memorized even when selecting the
Layer mode, but no change made in Layer mode will be preserved.
When the instrument is turned on, the effect settings are reset to the factory settings.
To save these settings, save them using the Data Dump function (see "MIDI Data
Dump" on page 35).
18
To return to the Single mode, just press a single
To a d j u s t t h e b a l a n c e
Chapter 3