Sirius SU906 Notice D'utilisation Et D'entretien page 14

Place the appliance inside the cabinet and
fix it by inserting the screws supplied into the
holes, as shown in fig. 19.
Both in the front and rear side of the applian-
ce, refit the stainless steel bar previously re-
moved, connect the led bar electrically by
means of the specific connector, and then
refit the grease filter.
Rear air outlet.
Models equipped with only one motor can
be installed having the motor air outlet orien-
ted towards the appliance rear side.
If you choose this option, you will need to
remove the motor support by removing the
12 screws (fig. 21), taking out and rotating
the support, placing it in its housing , always
keeping the air outlet oriented towards the
appliance rear side. (fig. 20).
Secure it by using the screws previously re-
moved.
If you intend to rotate the fan, in order to
orient the air outlet to the rear side of the
product, you must foresee the air outlet
channeling at 238mm distance from the lo-
wer surface of the wall unit (fig. 27).
Blocking of the stop valve Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
Exausting version
Connect the flange to the exhausting hole
with an appropriate pipe. Connect the ap-
pliance with the electrical mains through the
supply cord.
Filtering version
Connect the flange with a pipe suitable to
convey the air to the top of the cabinet. Con-
nect the appliance with the electrical mains
through the supply cord.
Chimney installation
Lift the internal steel chimney up to the top
of the wall unit (fig. 22), draw with a pencil
the rear end of the internal chimney on both
sides (fig. 23), lower the entire chimney and
position the fixing bracket in corresponden-
ce with the marking made (fig. 24), secure
the bracket with screws (fig. 25).
Lift the internal chimney up to cover the bra-
cket and secure it with screws positioned on
both sides (fig. 26).
14