Programming The Timer And The Activation Method For "Output 1 - BASETech 1833947 Notice D'emploi

The factory setting allows the relay output 1 "OUTPUT 1" (E) to be activated by ID card or user
code.
To assign the way in which the relay output "OUTPUT 1" (E) is to be activated proceed as
follows:
a) Activating "OUTPUT 1" (E) using an ID card or user code
To allow activation of "OUTPUT 1" (E) using an ID card or user code, enter the following key
combination:
3 00 #
b) Activating "OUTPUT 1" (E) via ID Card and User Number
3 01 #

10.7 Programming the Timer and the Activation Method for "OUTPUT 1"

To carry out this programming step the code lock should now be in programming
mode (see Chapter "10.1 Entering Programming Mode").
You can programme whether the relay output 1 "OUTPUT 1" (E) is activated only for a specific
period of time (01-99 seconds) or whether it should be blocked.
a) To assign an activation time for activation of the relay output "OUTPUT 1" (E) enter the
following key combination:
40 Time in seconds (you can programme from 01 to 99 seconds)
Example for 14 second activation time:
40 14 #
b) To block the relay output 1 "OUTPUT 1" (E) enter the following key combination:
41 #
The factory setting is a 3 second activation time.
#
45