BASETech 1833947 Notice D'emploi page 48

Enter the following key combination to set the unit to input method 1:
70 0 #
Enter the following key combination to set the unit to input method 2:
70 1 #
The factory setting is "7-00".
b) Setting Acoustic Signalling of Relay Activation
You can determine whether a signal tone should be emitted or not when the relay is activated.
Enter the following key combination to deactivate the signal tone when the relay is activated:
71 0 #
Enter the following key combination to activate the signal tone when the relay is activated (in this
setting a signal tone is emitted for 1 second when the relay is activated):
71 1 #
The factory setting is a deactivated relay activation signal tone.
c) Activating / Deactivating the Key Tone Function
Determine whether the key tones are to be activated or deactivated.
Enter the following key combination to deactivate the key tones:
72 0 #
Enter the following key combination to activate the key tones:
72 1 #
The factory setting is activated key tones.
d) Activate / Deactivate Intruder Alarm and Set Alarm Duration
Basic requirements for an alarm in the case of unauthorised entry are a sensor
(e.g. magnet contact) attached to the "DOOR SENS" and "GND" clamps.
Also be sure to note the example connection plans at the end of these instructions and Chapter
"8 Connection Plan".
Enter the following key combination to deactivate the alarm:
73 0 #
48