BASETech 1833947 Notice D'emploi page 39

Also be sure to note the example connection plans in these instructions when
connecting the device. These are located on the last page of these instructions.
A = TAMPER
This is the tamper switch output for the connection of an external alarm system.
H = High Potential, L = Low Potential, (N.C. contact)
B = Door bell connection (N.O. contact)
C = N.O. EG GND
Is for connection of an egress button
D = Operating voltage connection (12 V/DC)
E = OUTPUT 1
This is relay output 1, which has a variable contact (N.O. and N.C.).
F = OUTPUT 2
This is relay output 2, which has a variable contact (N.O. and N.C.).
G = "DOOR SENS" connection clamp
The "DOOR SENS" + "GND" allow you to connect a magnet contact or similar.
H = "ALM OUT" connection clamp
This is an alarm output for attaching, for example, an acoustic or optical signalling
device. This output delivers ground/earth potential as soon as it is activated.
I = "KEY ACT" connection clamp
Allows connection of an acoustic or optical signalling device. This output delivers
ground/earth potential as soon as it is activated.
N.C. COM N.O.
OUTPUT 2
F
Connection terminal 2
DOOR ALM
SENS GND
OUT
G H I
KEY
ACT
39