Lubrication - LGB 27510 Instructions De Service

If desired, numerous functions of the
onboard decoder, such as acceleration,
braking, direction of travel and many
others, can be programmed using a PC
and the 55045 MTS PC Decoder
Programming
Instructions for advanced users).
These functions also can be pro-
grammed from the 55015 Universal
Remote.
Lighting
This model features directional lighting.
The model has a "flat" multi-purpose
socket, with a removable cover, on
each end wall (Fig. 3). These sockets
can be used to provide track power to
LGB cars with lighting or sound elec-
tronics.
To remove the cover of a socket, pull it
straight out. If the cover is tight, gently
use a small straight screwdriver to pry
it out. (Do not pull out the rectangular
outer housing.)
Power Supply
Attention! For safety and reliability,
operate this model with LGB power
supplies (transformers, power packs
and controls) only. The use of non-LGB
power supplies will void your warranty.
Use this model with LGB power sup-
plies with an output of more than 1
amp. For more information on LGB
power supplies for indoor, outdoor and
multi-train operation, see the LGB cat-
alog.
Attention! After extended operation,
this model may leave carbon dust or
other debris around the track. This dust
and debris can stain carpet and other
materials. Consider this when setting
up your layout. LGB are not liable for
any damages.
Module (see
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will void
your warranty. For quality service, con-
tact your authorized retailer or an LGB
factory service station (see Authorized
Service).

Lubrication

The axle bearings and the side rod ends
should be lubricated occasionally with
a small amount of LGB Maintenance Oil
(50019).
Cleaning
This model can be cleaned externally
using a mild detergent and gentle
stream of water. Do not immerse this
model.
Replacing the light bulbs
Front and rear lanterns:
These bulbs are mounted on circuit
boards at each end of the model
(Fig. 4). To replace these bulbs, you
must remove the body of the model
from the chassis:
- Remove the eight vertical screws on
the bottom of the chassis.
- Remove the body of the model.
- Remove the appropriate circuit board.
- Remove and replace the bulb.
- Reassemble.
Cab light: Using tweezers, remove and
replace the bulb.
Replacing the traction tire
- Remove the two screws in front of
and behind the gearbox with the trac-
tion tire.
- Carefully pull out the gearbox until
you can reach the traction tire.
- Use a small, straight-blade screwdriv-
er to pry the old traction tire out of the
wheel groove.
11