Grease Filters; Odor Filters - ETNA ABE590 Série Mode D'emploi

MAINTENANCE

Grease filters

Odor filters

EN 8
Removing the grease filters
Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Pull the grease filter towards you and tilt
it downwards at the front.
Installing odor filters
Odor filters must always be used if the cooker hood is not ducted.
1. Remove the grease filters.
2. Attach the odor filters in the motor housing; position the tabs and
attach the holder with the odor filter.
3. Replace the grease filters.
The functioning:
• More noise is produced when odor filters are used than when the
cooker hood is used with an exhaust vent.
• Odor filters function optimally at a lower motor speed.
Removing the odor filters
1. Remove the grease filters.
2. Push the mounting clip on the holder, tilt the holder down and
remove it from the motor housing.
Cleaning the odor filters
• Clean the odor filters every 3 months. After up to 2 years (or if the
filtres are damaged), the filters will need to be replaced.
• The regenerable active odor filters can be washed by hand or in
the dishwasher at a maximum temperature of 65 °C. The washing
cycle must be done without other dishes and without dishwasher
detergent. Do not use any cleaning agents!