Sony UP-2100P Mode D'emploi page 70

Setting Up the Printer (continued)
70
Installation and Adjustment
3
Select OFF by pressing the ı or ∫
button.
To display screen messages
Select ON in step 3.
Note
If you set the printer output signal specification to THRU (through), screen
messages do not appear, even when you switch ON to green. However, error
messages can appear at any time.
4
Press the MENU button.
The regular screen appears.
To temporarily erase the monitor display
When the MENU screen arrears: While the DISPLAY OFF button on the sub
panel is held down, the screen display disappears, even if DISPLAY OFF is set
to ON. Upon releasing the DISPLAY OFF button, the screen display appears
again.
When the regular screen arrears: The screen messages switches on the and off
whenever you press the DISPLAY OFF button, regardless of the menu setting
on the OUTPUT SETUP menu.
PR I N T E R SE T UP CO L OR n n n
/ P I X / L A Y / P R N / I N / OUT /
D I S P L A Y OF F / ON
SOURCE T HR U / E E
Switch OFF to green by
pressing the ı or ∫ button.