Sony UP-2100P Mode D'emploi page 67

5
Select the desired timing to capture the
image by pressing the ı or ∫ button.
Timing
To capture the image just after the CAPTURE command is received
To capture the image with the timing pulse input to REMOTE 2 connector
a) When IMMED. CAP is set to ON, display the source image on the video monitor when sending
the timing pulse to the printer. The printer operation is only to capture the image when receiving
the pulse.
b) For detailed information on the timing pulse to REMOTE 2 connector, see page 76.
Notes
• To control the printer remotely using the remote control unit, set the
IMMED.CAP item on the FUNCTION SETUP menu to OFF.
• To send the puls signal on an accurate timing to the REMOTE 2 connector
using a computer, set the IMMED.CAP item to ON.
6
Select RM2 FUNC by pressing the ◊ or
√ button.
FU NC T I ON S E T UP CO L OR n n n
P R N SE TU P P R E S S
A U TO L I V E OF F / ON
I MM ED. CA P. OF F / ON
RM2 F U NC
PR I NT /
CL E AR
ALL /
Q 1 A 1
Switch the desired timing selection to
green by pressing the ı or ∫ button.
Selection
a) ON
b) OFF
FU NC T I ON S E T UP CO L OR n n n
P R N SE T UP PRE SS
A U T O L I V E OF F / ON
I MME D . C A P. OF F / ON
R M 2 F U NC PR I NT /
C L E A R ALL /
Q 1 A 1 S
Position the cursor to RM2 FUNC
by pressing the ◊ or √ button.
Continue to next page m
Installation and Adjustment
S
67