Sony UP-2100P Mode D'emploi page 64

Setting Up the Printer (continued)
64
Installation and Adjustment
When a black line appears on the
printout
Adjust the printout area according to
the position of the line on the printout,
by using the H START and V START
items on the menu.
Position where Menu adjustment
the black line appears item
On the right H START
(horizontal direction)
On the left
At the top V START
(vertical direction)
At the bottom
To clear the adjusted value
Press the MENU button from the WINDOW SETUP menu. The adjusted
values are cleared and the values are reset to the original ones.
Note
When a black line still appears, even after adjusting H START or V START,
change the printout size.
5
Select LAY SETUP by pressing the ◊ or √ button, then press the ∫ button.
The adjusted values are stored. The LAYOUT SETUP menu appears.
6
Press the MENU button.
The regular screen appears.
To check the adjustment result
Cature a new image and print it to check that no black frame appears on the
printout, that the image is not partially cut, and that no black line appears.
When the black line is
at the right or left edge
W I NDOW S E T UP CO L OR n n n
L A Y SE T U P P R E S S
H S T A R T 00 D OT
00 D OT
V S T A R T
H W I DT H 720 D OT S
V W I DT H 468 D OT S
Q 1 A 1
When the black line is
at the top or bottom
Button to be Adjustment result
used
∫ button The image position shifts to the right
with the size remaining as is.
ı button The image position shifts to the left
with the sized remaining as is.
∫ button The image position shifts up with the
size remaining as is.
ı button The image position shifts down with
the size remaining as is.
( S )
S
( )
S