After Use; Maintenance And Storage - Nakayama PS2700 Traduction De La Notice Originale

weight! This prevents stripping the bark from the
main member!
f ). Never stand on a ladder or other type of
unstable support while using the product.
Insecure
stand invites hazards. (See Fig. 15e)
WARNING! This product has not been
designed to provide protection from
electric
shock in the event of contact with overhead
electric lines! Therefore do not use product
near cable, electric power or telephone lines.
Keep a minimum distance of 10 m to all electric
lines. (See Fig. 15f )!
g). Use the product only with secure footing.
Hold the product at the right-hand side of your
body.
h). Do not operate the product with arms fully
extended or attempt to cut areas which are
difficult to reach.
i). Keep a firm, steady pressure on the product
while working with it. Do not try to force the
product through the wood, let the cutting device
do the work, using the gripping teeth to apply
minimal leverage pressure.
j). Beware when reaching the end of the cut. The
weight of the product may change unexpectedly
as it cuts free from the wood. Accidents can occur
to the legs and feet. Always remove the product
from a wood cut while it is running.
NOTE: The chain must be running at full speed
before it comes into contact with the wood.
8. Cut thin branches
Thin branches can be cut off with one single cut.
To prevent the branch from slivering and
buckling the branch should be cut off in several
pieces. (See Fig. 16)
9. Cut thick branches
When cutting larger branches, three cuts are
necessary as shown below:
20
a). First cut into the branch from below, outside
of the location where you intend to cut off the
branch. The cut should go one third to halfway
through the branch. (See Fig. 17a)
b). Cut into the branch from the top, outside from
where the branch is to be sawn. (See Fig. 17b)
c). Last, cut off the stump with one clean cut from
top to bottom. (See Fig. 17c)
d). You might want to seal the cut with a suitable
compound.
NOTE: Remove the branches lying on the floor
regularly to avoid stumbling hazards. Check
the oil level regularly and fill up if necessary.
Switch the power off and disconnect from power
source when leaving the product.

10. AFTER USE

1). Switch the product off, allow the engine to
cool down and then remove the spark plug
connector.
2). Check, clean and store the product as
described below.

Maintenance and storage

1. Improper maintenance , use of non-
conformant replacement components, or the
removal or
modification of safety components leads to
hazards causing injuries and damage to property.
2. When the product is stopped for servicing,
inspection or storage, shut off the power source,
disconnect the spark plug connector from the
spark plug and make sure all moving parts have
come to a stop. Allow the product to cool before
making any inspections, adjustments, etc.
3. Always store the product and fuel so that
there is no risk of leakages or fumes coming
into contact with sparks or naked flames from
electrical equipment, electric motors, relays/
switches, boilers etc. Always allow the product to
cool down before storing.
4. When not in use store the product out of the
reach of children.
5. Use only manufacturers recommended