Nakayama PS2700 Traduction De La Notice Originale page 25

TROUBLESHOOTING
WARNING! Suspected malfunctions are often due to causes that the user can fix themselves. Therefore
check the product using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All further inspection,
maintenance and repair work must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Problem
Engine does not
start
Engine stops
Unsatisfactory
cutting
performance
Excessive
vibration/noise or
exhaust
Possible cause
Not enough fuel in fuel tank
Primer has been not pressed at cold start
Primer has been pressed at warm start
Spark plug is wet
Spark plug is damaged
Spark plug connector lose
Not enough fuel in fuel tank
Cutting device is blocked
Cutting blade is dull/damaged
Cutting material exceeds capacity
Cutting device is dull/damaged
Bolts/nuts are loosen
Petrol/oil is incorrect
Fault correction
Add fuel
Press the primer and restart
Dry spark plug
Dry spark plug
Replace spark plug
Attach properly
Add fuel
Remove blockage
Have a specialist to sharpen
or replace it
Only cut materials acc. to the
capacity of the product
Replace with a new one
Tighten bolts/nuts
Empty unused petrol/oil and
refill with the correct petrol/oil
25