Auxiliary Handle; Starting And Stopping - Nakayama PS2700 Traduction De La Notice Originale

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING! Do not suddenly release the
recoil starter handle! Always allow it to
return under controlled tension!
3. HARNESS
The harness (A8) helps the operator carry this
product.
WARNING! Always attach the product to
the harness. Do not carry it just by hand!
1). To remove the harness from the loop, open
the securing clip (A10).
2). Place the harness so that it runs over the
left shoulder, crossing the chest and back. The
securing clip must be located at the right hip. (See
Fig. 9)
3). Adjust the length of the harness (A8) so that
the hook is approximately 15 cm below your
waist; locate the product to the harness by using
the securing clip ensuring that the angle of the
cutting head is parallel to the surface being cut.
WARNING! Always attach the product to the
harness. Do not carry it only with your hands.
4). In case of emergency, pull the rope of the
quick release mechanism. The metal locking
bar will be released from the securing clip
automatically because of the weight of the
machine, and the machine will drop away from
you. (See Fig. 10b)

4. AUXILIARY HANDLE

Adjust the position and angle of the auxiliary
handle (A15) on the upper shaft.
1). Loosen the bolts on the auxiliary handle (A15)
and adjust the position. (See Fig. 11)
2). Afterward tighten the bolts.

5. STARTING AND STOPPING

GENERAL BEHAVIOUR
1). Check the product as well as accessories for
18
damage before each use. Do not use the
product if it is damaged or shows wear.
2). Double check that accessories, safety guards
and blades are properly fixed.
3). Always hold the product the product by its
handles. Keep the handles dry to ensure safe
support.
4). Ensure that the air vents are always
unobstructed and clean. Clean them if necessary
with a soft brush. Blocked air vents may lead to
overheating and damage the product.
5). Switch the product off immediately if you are
disturbed while working with it and when other
people enter the working area. Always let the
product come to complete stop before putting it
down.
6). Do not overwork yourself. Take regular breaks
to ensure you can concentrate on the work
and have full control over the product. Always
switch the engine off if you make a break or
move to another area.
7).It is necessary to change the working positions
regularly.
This product is controlled by the control handle.
For operation three steps are necessary:
Firstly, the ignition switch (A19) must be put into
its on position "I". Then the throttle interlock
(A20) must be pressed to disengage the throttle
trigger. Finally press the throttle trigger (A18).
(See Fig. 12a)
1). Starting
a). Place the product on a flat, stable surface.
Ensure that the attachment in use does not
touch the ground or any objects.
b). Set the ignition switch (A19) to its on position
"I". (See Fig. 12b)
c). If the engine is cold, move the choke lever (A3)
to the "CLOSE" position
the primer (A4) with 6 times until fuel is visible.
(See Fig. 12c)
d). If the engine is warm, move the choke lever
(A3) to the "OPEN" position
the primer. (See Fig. 12d)
and depress
, do not press

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

017202

Table des Matières