Water Connection - Angelo Po 1G1PI1E Manuel D'utilisation Et D'installation

ASSEMBLING APPLIANCES IN BANKS
To assemble appliances in banks (side by side)
proceed as described below.
1 - Remove the control panels.
2 - Apply masking tape to the edges to be placed
side by side.
3 - Apply food-approved sealant to the edges to be
placed side by side.
4 - Place the appliances alongside each other and
level them (see "Levelling").
5 - Connect the appliances with the fixing devices.
6 - Remove the excess sealant and the masking
tape.
7 - Apply the sealant to the inside of the lid (A), and
fit it to cover the fixing zone.

WATER CONNECTION

To make the connection, connect the mains line to
the appliance's connection pipe, fitting a shut-off
tap (A), to allow the water supply to be cut off when
necessary. Easily accessible filters must be fitted
IT
downstream of the tap.
GB
Caution - warning
The appliance must be supplied with drinking
water having the characteristics shown in the
DE
table.
Description
FR
Pressure
pH
ES
Conductivity
Hardness
Salt and metallic ion
content
Chlorides
Sulphates
Iron
Copper
Manganese
English
Value
200÷450 kPa (2÷ 4 bar)
7÷7.5
< 200 mS/cm
9÷13° f (5÷7° d, 6.3÷8.8° e,
90÷125 ppm)
< 30 mg/l
< 40 mg/l
< 0,1 mg/l
< 0.05 mg/l
< 0,05 mg/l
- 14 -
A
IDM-39603603000.tif
A
IDM-39616401300.tif