Functional Problems; Disposal - VOLTCRAFT LSP-1165 Mode D'emploi

9. FUNCTIONAL PROBLEMS

The lab mains unit does not work, the displays are not lit:
• Check the on/off switch (switch position "I" = on).
• Check that the mains cable is firmly connected to the lab mains unit and whether it is plugged into a proper mains
socket with protective contact (wall outlet).
• Check the functionality of the mains socket (e.g. fuse, circuit breaker, fault interrupter protection switch).
The connected consumers do not work:
• Check polarity at the DC output sockets (6, 12).
• Check that the current limitation is activated; if required, set a higher value for current limitation (or set the maxi-
mum value).
• Observe that the lab mains unit has three different voltage/current ranges that can be selected via the three but-
tons "16V/5A" (5), "27V/3A" (11) or "36V/2.2A" (10); see chapter 7. b).
When the consumer needs, for instance, an operating voltage of 30 V/DC, select the corresponding range with the
button "36V/2.2A". Only an output current up to 2.2 A is available here, however.
• Reduce the load of the lab mains unit.
• Check the technical data of the consumers (operating voltage, current consumption, voltage type).

10. DISPOSAL

Electronic devices are recyclable and should not be disposed of in household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
28