Cleaning And Maintenance; Cleaning; Fuse Replacement - VOLTCRAFT LSP-1165 Mode D'emploi

8. CLEANING AND MAINTENANCE

The lab mains unit is maintenance-free for you apart from occasional cleaning and fuse change; never
disassemble it.
Opening of the lab mains unit, maintenance and repairs must only be done by a specialist.
a) Cleaning
Always switch off the lab mains unit before cleaning and disconnect it from the mains voltage (pull the mains plug).
Clean the product only with a dry, soft, clean cloth. Dust can be removed easily with a dry, clean brush and a
vacuum cleaner.
Do not use any aggressive cleaning agents for cleaning, or even chemicals; this may cause not only discolouration
but also damage to the product.
b) Fuse replacement
The fuse can trip at overload or if the lab mains unit is defective.
Proceed as follows for to replace the fuse:
Attention!
Switch off the lab mains unit first. Pull the mains cable from the lab mains unit; also disconnect the con-
nected consumers from the lab mains unit.
Use a flat screwdriver to pull out the fuse holder (the slot at the fuse holder is within the mains socket).
Replace the defective fuse with a new fuse of the same build (same type, same rated current, and same trigger
characteristics); see chapter "Technical data").
Plug the fuse holder back into the fitting until it latches.
Then check for correct function of the lab mains unit.
If the fuse trips again (even if there is no overload or no consumer is connected), switch off the lab mains
unit and disconnect it from the mains voltage. Then have the lab mains unit inspected by a specialist.
27