Elem Garden Technic TRT2531-2 Traduction Des Instructions Originales page 81

Spiked bumper
Device placed in front of the mount point of the bar and
rotates when it is in contact with a tree or log.
Mounting the claw
chaîne
5. clutch
6. Hole of the guide bar
7. tensioner
8. Brake connector
9. Direction to tension the chain
10. Front hand guard (brake lever)
1. Loosen the chain brake
2. two nuts
3. Clutch
(1) Claw slaughter
(2) Two bolts
Unscrew the two nuts and remove the cover
Ask the spiked bumper on the machine
Tighten the two bolts (2)
Install guide bar and drag chain.4. Guide-
Fit the chain as shown.
(Make sure the teeth are pointing in the right
direction)
release the brake system, then install the clutch
cover by positioning pins on the guide bar.
Hand tighten the two nuts.
Make sure the chain tensioner
properly in place in the hole in the chain guide.
81