Lifting The Vehicle; Lowering The Vehicle - Nussbaum SPRINTER MOBIL 2500 Manuel D'exploitation

Vehicle with front-wheel drive:
Vehicle with rear-wheel drive:
5.1

Lifting the vehicle

Warning! The hydraulic lines may not be driven
!
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
The total centre of mass must be considered.
!
i If required, use the ramps for safe acceptance
of the vehicle.
64
• Secure the vehicle against rolling; pull the hand
brake, engage the gears.
• Inspect the hazardous area.
The center of gravity
No person or object may stand in the working
of the vehicle inclu-
area of the lift, or on the lift.
ding load must be
• Switch on controls. Turn the main switch (2) to po-
between 100 mm
sition „1" (see figure 007).
and 600 mm from
• Position polymer overlays below the points spe-
the stationary bea-
cified by the vehicle manufacturer. The polymer
ring towards the
overlays may not be placed on edge, otherwise
middle of the lift.
the vehicle could fall.
• Lift the vehicle. Push the „LIFT" (3) button.
fixed bearing
• If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the po-
CG = center of gravity
lymer overlays.
• Raise the vehicle to the desired working height.
fixed bearing 008
• Then position the operating unit in such a way
that the flexible hose package (protective and
hydraulic hose) cannot be damaged by exter-
nal influences (such as being driven over by the
load)
The center of gravity
of the vehicle inclu-
5.2
ding load must be
between 100 mm
!
and 600 mm from
the stationary bea-
ring towards the
middle of the lift.
• Inspect the hazardous area. No person or object
may stand in the working area of the lift, or on the
fixed bearing
lift.
CG = center of gravity
!
fixed bearing 009
The center of gravity
of the vehicle inclu-
ding load must be
between 100 mm
and 600 mm from
the stationary bea-
ring towards the
middle of the lift.
CG = center of gravity
fixed bearing 010
• Lower the vehicle to the desired working height.
Push the „LOWER" button (4) (see figure 007).
• The system is equipped with an optional CE-STOP
During „LOWER" (4) to the lowest position, the sys-
tem stops at a height of 300 mm.
To allow the system to lower further, it is necessa-
ry to release the „LOWER" button (4) and press it
again.
OPI_SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000_V2.3_DE-EN-FR-ES-IT

Lowering the vehicle

Warning! The hydraulic lines may not be driven
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
The vehicles cannot be lowered into the lowest
position without wheels. Otherwise the lift can-
not raise the load using its own force. The vehi-
cle could be damaged.
015