Selecting The Anchors; Assembly - Nussbaum SPRINTER MOBIL 2500 Manuel D'exploitation

• Place the guide rollers (6) over the torsion shafts
(7). Then push them until the tappet (10) is loca-
ted in the notch (11) of the guide roller.
6 Guide roller
10 Tappet 11 Notch
• The wheel axles (9) are in the lower plate of the
lift (12).
9
9 Wheel axle
12 Wheel axle storage
To simplify mounting, it may be necessary to rai-
i
se or lower the lift a little.
• Then lower the lift completely. Hang the tow bar
(8) into the guide roller (6) and the lift can then
be moved.
• To remove the roller, follow the instructions in the
reverse order.
• The mobile hand unit quickly makes the SPRINTER
MOBIL - HYMAX PRO ready to use again.
• To change the setup location of an anchored lift,
the conditions according to the setup guidelines
in Section 4.1 must be ensured.
Use new anchors. The old anchors are no longer
!
fit for purpose!
70
19
6
11
10
19 Guide roller holder
12
OPI_SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000_V2.3_DE-EN-FR-ES-IT
8.4

Selecting the anchors

• Liebig anchor without floor cover (screed)
Safety anchor with threaded bolts and nuts
BM 10-15/70/40
• Liebig anchor with floor cover (screed)
Safety anchor with threaded bolts and nuts
BM 10-15/70/xx (length of the anchor depends on
the floor covering)
• Fischer anchor without floor cover (screed)
High quality anchor FH II­B (bolts and nuts)
FH II 15/50 B
• Hilti anchor without floor cover (screed)
Heavy duty anchor
HSL-3-G M10/40
• Hilti anchor without floor cover (screed)
Heavy duty anchor
Hilti HIT-V-5.8/M10/130
i Similar value anchors and other known brands
005
of anchor manufacturers can be used when
considering the conditions.
8.5

Assembly

i Follow the instructions enclosed in the anchor
packaging.
019
011