Commissioning; Changing The Assembly Location - Nussbaum SPRINTER MOBIL 2500 Manuel D'exploitation

partner. If the operating company has appropri-
ately trained assemblers, the system can also be
set up by them. Set up is to be done according to
the assembly instructions.
• A standard system may not be set up in explosion
endangered spaces or wash halls.
• Provide an on­site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
i The foot bumper (15) must always be mounted
with the orange sticker (16) on the side where
the cylinder (17) is located.
18
15
15 Foot bumper
16 Orange sticker
17 Cylinder
18 Load capacity sticker
8.2

Commissioning

2
1 Cover hood 2 Main switch
3 "LIFT" button 4 "LOWER" button
• Remove the front cover hood (1)
• Loosen and remove the sealing screw (5) of the
oil tank
OPI_SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000_V2.3_DE-EN-FR-ES-IT
16
17
illustration similar 022
3/4
1
5 Oil filling opening
• Fill new hydraulic oil (e.g. HLP 32). About 8 litres
are needed.
• Provide an on­site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
• Connect the electric cable to the customer-pro-
vided mains breaker (e.g. a Cekon plug).
• Turn on main switch (2) and press the „LIFT" button
(3).
If the lift does not move upwards after a few se-
!
conds, the direction of rotation of the motor is
incorrect. Swap 2 phases on the plug.
• Then press the „LIFT" button (3) again and raise
and lower the lift to its limit positions several times
without load. This will largely ventilate the hydrau-
lic system.
8.3

Changing the assembly location

• To operate the lift, it must be raised about 500 mm
so that the back wheel axes (9) and guide roller
(6) can be engaged.
8
7
6 Guide roller
7 Torsion shaft 8 Towing bar
5
026
003
9
6
illustration similar 004
9 Wheel axles
69