Operating Manual; Operating Element; Lifting The Vehicle; Lowering The Vehicle - Nussbaum JUMBO LIFT 3500 NT Mode D'emploi

Made
in
Germany
5

Operating manual

When handling the system, it must
absolutely comply with safety reg-
ulations. Carefully read the safety
regulations in Section 3 before first
operation!

5.1 Operating element

4
1
1 Main switch
o
2 „Lift" button
u
3 „Lower" button
X-TEND
2
3
4
Operating lever
1 Lift + Press = LIFT
2 Home position
3 Lift + Pull = LOWER
80
2
3
003
4 CE-Stop button
1
4
Operating elements
4 CE-Stop button

5.2 Lifting the vehicle

• Drive the vehicle over the drive rails lengthwise and
cross-wise in the centre.
• When driving onto the lift, position the ramps so that the
rollers (7) of the ramps (9) are on the ground.
9
7
7 Rollers
8 Supports
9 Ramps
Otherwise the supports (8) and ramps (9) can be dam-
aged.
• Secure the vehicle against rolling. Apply the hand-
brake, put into gear.
• Position polymer overlays below the receiving points
approved by the vehicle manufacturer.
i If required, use the ramps for safe acceptance of the
vehicle. If the wheel base is too short, fold the ramps
underneath.
To receive the vehicle, the polymer
overlays cannot be placed on edge
otherwise there is a danger of the
car falling.
• Inspect the hazardous area.
No person or object may stand in the working area of
the lift, or on the lift.
• Switch on controls. Turn the main switch (1) to position
„1" (see figure 003).
• Lift the vehicle. Push the
• X-TEND: Lift the vehicle. Activate the
lever.
• If the wheels are not blocked, interrupt the lifting process
and check for proper seating of the polymer overlays.
• Raise the vehicle to the desired working height. Push the
o „Lift" (2) button.
• X-TEND: Raise the vehicle to the desired working height.
Pull the o "Lift" operating lever.

5.3 Lowering the vehicle

• Inspect the hazardous area.
No person or object may stand in the working area of
the lift, or on the lift.
The vehicles cannot be lowered into the low-
!
est position without wheels. Otherwise the
lift cannot raise the load using its own force.
The vehicle could be damaged.
OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT
o „Lift" (2) button.
o "Lift" operating
8
004