Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
POSITIONING THE COMPONENTS OF THE SYSTEM
All the parts of the system should be installed in hidden locations which are difficult to access
and away from heat sources.
Alarm unit
Fit in the passenger compartment using the double-side adhesive material provided. The alarm
unit main connector should exit downwards.
O.K.
Siren with back up battery
Fit in the engine compartment taking
care of orienting it as indicated in
the drawing.
1
NO
Ø 3 mm.
Siren without back up
4
battery
2
Fit in the engine compartment, using
the screws provided, to a metal
surface to facilitate heat dissipation.
3
Volumetric ultrasonic sensor
Fit the transducers at the top of the 'A'
pillars each side of the windscreen, taking care that they are not covered when the sunvisors
are down.
If the car is equipped with sliding sunroof, do not fit the transducers on the dashboard.
Check the right position of the transucers during the functional test of the system.
No adjustment is required for the volumetric ultrasonic sensors. It is suitable for every kind of
vehicle indipendent of the compartment volume.
When transducers are not connected or the originals transducers are present yet, insert the
jumper (code 05FA0230A) into the RX connector.
Glass break sensor (if applicable)
Fit the microphone in a central position in the passenger compartment. Eg. on the dashboard, pointing
towards the rear window. This position achieves uniform sensitivity. The sensor can be used in conjunction
with the ultrasonic volumetric sensor. Drawings in the central part of this manual shows different connection
methods.
GB
15
GLOBE 4800/4900 CAN FITTING INSTRUCTIONS
06DE2178B.pmd
15
28/05/2007, 10.42
Publicité
Table des Matières
