Electrical Connections - Cobra GLOBE 4800 CAN Manuel D'installation

Bonnet switch
The bonnet switch must be installed, if not already present or not managed by CAN-BUS, to facilitate
programming of the alarm. Check that the switch is depressed by at least 5 mm when the bonnet is closed.
Ensure that the switch is not acting against sound proofing as these materials could deform over time.
Control panel
Install on the dashboard in an accessible position. The LED should be visable from outside the vehicle. In
addition to its deterrent function, the panel (LED + push button) is used for programming and for emergency
override.

ELECTRICAL CONNECTIONS

Refer to the enclosed wiring diagrams, and take note of the following:
• route the alarm wires along side the original vehicle harness.
• the system ground must be connected to an original vehicle ground point.
• connect the alarm unit negative and positive feed before reconnecting the car battery.
• the positive supply to the system, must be protected by an adequate fuse located close to the
point of connection (see main diagram).
Blinker
The product disposes of two kind of output, able to generate the necessary commands to
activate the turn indicators, named blinker power and blinker logic.
The two kinds of blinker are in alternative to the other, and it is possible to activate only one of
them.
"Power" or "logic" command selection is default according to the vehicle platform type.
For the electrical connections refer to vehicle fitting document.
PROGRAMMING THE SYSTEM
Many functions of this alarm are programmable.
The programmable functions are divided in the following tables: buzzer, basic functions, advanced
functions. Refer to the user manual for their working description.
HOW TO PROGRAM THE SYSTEM
Disarm the system, open a door and the bonnet and turn the ignition key ON. Digit the PIN code. If all
conditions are satisfied, the LED of the control panel will flash and after about 3 s the system will react with
a flashing of the turn indicators to signal that you are into programming-mode in the buzzer table (buzzer
volume control). To reduce the volume of the buzzer, press for a longer time the button on the control panel.
The volume of the buzzer will reduce at each pression. To increase the volume make the same sequence
keeping pressed the button quickly for few times. The volume of the buzzer will increase at each pression.
Turn the ignition key OFF then ON to go to the next table. The turn indicators will flash twice to indicate that
you are in the basic functions table. This signal is repeated every 10 s to indicate which table you are in.
Turn again the ignition key OFF and then ON to go to the advanced functions table. The system will confirm
the new table with 3 turn indicator flashes.
GB
16
FITTING INSTRUCTIONS GLOBE 4800/4900 CAN
06DE2178B.pmd 16 28/05/2007, 10.42