Medisana BS 460 Mode D'emploi page 11

• WARNING! Please ensure that the polythene packing is kept away from
the reach of children! Risk of suffocation!
• Keep batteries out of children's reach! Do not disassemble batteries! Do
not attempt to recharge batteries! Do not short circuit! Do not throw into
a fire!
2 Items supplied
• 1 Medisana body analysis scale BS 460 with detachable display
• 7 Batteries 1.5 V, type AAA
3 Insert/replace battery
The insulating strip may be pulled out of the battery compartment
before the scale can be operated. Replace the batteries if the battery change symbol "LO" appears in
the display or if nothing appears in the display at all. Please note polarity (like shown in the battery
1
compartment). Place the batteries in the detachable display like this:
Disposal
This product must not be disposed of together with domestic waste. All users are
obliged to hand in all electrical or electronic devices, regardless of whether or
not they contain toxic substances, at a municipal or commercial collection point so
that they can be disposed of in an environmentally acceptable manner.
Please remove the battery before disposing of the device/unit. Do not dispose of
old batteries with your household waste, but at a battery collection station at a
recycling site or in a shop.
4 Change the unit of weight
You may have your weight displayed in kilograms (kg), pounds (lb) or stones (st). Touch button
switch to weight mode. Then choose the unit of weight by touching UP or DOWN button.
5 Weighing
1. Make sure the scales are on a firm, level surface. Press your foot on the middle of the surface of
the scales. Touch button
2. Step onto the scales and stand still.
3. Your weight is measured, flashes two times and is then finally displayed.
4. Step down from the scales. The scales switch off automatically after approx. 9 seconds.
6 Hang up/put up display
1. Pull out the display from the bottom of the scales.
2. Hang up the display on a hook/holder or place the display near the scales by using the foldable
stand.
7 Set clock
1. Touch button
3
2. Simultaneously touch and hold the UP button
3. Adjust the time format (12 or 24 hours) with the UP
with SET . (You can adjust time format in standby mode anytime with UP or DOWN button)
4
4. Adjust the hours with the UP and DOWN buttons and confirm with SET
5. Adjust minutes the same way.
• 1 Instruction manual
to switch to weight mode - "0.0 kg" appears in the display.
3
to switch to weight mode - "0.0 kg" appears in the display.
on the underside of the unit
6
and SET button
2 4
or DOWN button
2
ENGLISH
3
until digits start flashing.
and confirm
5
.
4
to
7