Power Supply - Steba DG 5 Mode D'emploi

Check your microwave: The appliance should be taken out of the packaging. Remove
all packaging material and check the appliance if there is any damage like broken
door handles or cracks at the door. If there are any damages contact your trader.
Never use the appliance when it is damaged!
Earthing of the appliance:
Important: The appliance must be earthed correctly to ensure the personal safety.
When your AC socket is not earthed, then it is the personal responsibility to exchange
it to a correct earthed socket.

Power supply:

Only connect the appliance to the power supply according to the data shown on the
rating label. If a higher Voltage is used then shown on the rating label fire or other
damages can occur.
Position of the appliance:
1. Place the appliance on a stable non-sensitive surface.
2. Position the appliance in such way that the supply socket or the socket switch is
readily accessible so it can be easily disconnected.
3. For correct working it is important that enough space is around the appliance. The-
re should be a gap of at least 15cm above the steam microwave, 10 cm behind and
5cm at each side.
4. To disconnect the appliance from the power supply the plug of the power cord
must be easy to access.
Installation:
∙ This steam microwave must only be used on a table or on a working plate. It is not
suitable for build in use, like a cupboard.
∙ Do not place the appliance near an electrical or gas stove.
∙ Do not remove the feet
∙ The appliance must only be used inside. Do not use it outside, e.g. garden.
∙ The appliance should not be used in a damp area.
∙ The power cord should not touch the outside housing. Keep the power cord away
from hot surfaces. Never pull the power cord over edges of tables or working
places. Do not immerse the cable or the plug in water.
∙ The cooling opening at the sides and the back of the housing must not be blocked.
When they are blocked during usage the appliance can be overheated.
∙ Do not pull at the power cord or pinch it.
40