Chain counter and sensor hole template
Starting up
The chain counter features a graphic display and three keys:
also a buzzer that indicates the pressing of the keys or attracts the user's attention in particular conditions
(alarm triggering).
In order to turn the device on press the key ON for 3 seconds. It must also be used to access the
parameter setting menus. For selecting the parameters to be modified and to confirm the values set. The
instrument will switch off 30 seconds after the last command given (adjustable default time – see "Turnoff
Time").
The UP key commands the hoisting of the anchor and the DOWN key casts it. When the key is released,
the action is stopped. During parameter setting, the two keys allow the User to move around the menu
and vary parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
EV030-Radio
45,6 mm
(ON),
21
English
sensore magnetico
magnetic sensor
min.44 mm(1"3/4)
(UP) and
(DOWN). There is
Rev. 07 – 2014