MZ electronic EV030-Radio Instructions D'utilisation page 20

For instructions on making electrical connections, see the attached diagram. The wires must
•
have a minimum cross section size of 1.5 mm².
Install a 4 A (ampere) fast safety fuse on the + wire of the battery. Do not use the voltage
•
generated by the engine battery set to provide power.
The instrument complies with EMC standards (EN55022) and must be positioned at a distance
•
of:
30 cm (~1 Ft) from the compass;
−
50 cm (~1.5 Ft) from radio equipment;
−
2 metres (~6.5 Ft) from radio transmitter equipment;
−
2 metres (~6.5 Ft) from the radar beam.
−
Radio Chain Counter Connections
6
7
8
9
10
EV030-Radio
1
2
3
4
5
Transmitter-Receiver Power Unit Connections
6-POLE CONNECTOR
PIN
1 V Battery +
2 V Battery -
3 DOWN Command
4 UP Command
5 Magnetic sensor
6
10-POLE REAR CONNECTOR
PIN
1 V Battery +
2 V Battery -
SEGNALE
20
English
SIGNAL
Rev. 07 – 2014