sylvac Fowler Mark VI Mode D'emploi page 14

11. List of the main commands
E
Selection and configuration
CHA+ / CHA-
FCT0 ...9...A...F
MM / IN
KEY0 / KEY1
MUL [+/-]xxx.xxxx
PRE [+/-]xxx.xxx
REF1 / REF2
STO1 / STO0
TOL1 / TOL0
LCAL dd.mm.yy
NCAL dd.mm.yy
TOL +/-xxx.xxx +/-yyy.yyy Inputting nominal and current tolerance limits
+/-zzz.zzz
MIN /MAX /DEL /NOR
CLE
UNI1 / UNI0
OUT1 /OUT0
PRE ON / PRE OFF
PRE
SET
RES2 / RES3
Change measurement direction
Assign «favourite» function
Change measurement unit
Lock / unlock keypad
Modify multiplication factor
Modify preset value
Change active reference
Activate / de-activate HOLD
Activate / de-activate tolerances
Modify last calibration date
Modify next calibration date
Selecting MIN, MAX, Delta, Normal mode
Re-initialisation of MIN, MAX or Delta
Activate / de-activate change of units
Activate / de-activate contin. data transmission
Activate / de-activate Preset function
Recall Preset
Zero reset
Change of resolution
Interrogation
CHA? Measurement sense?
FCT? «favourite» function active?
UNI? Measurement unit active?
KEY? Keypad locked?
MUL? Multiplication factor?
PRE? Preset value?
REF? Reference active?
STO? Status of HOLD function?
TOL? Current tolerance limit values?
LCAL? Date of last calibration?
NCAL? Date of next calibration?
? Current value (mode Tol, value followed by <=>)
MOD? Active mode (MIN, MAX, Delta or Normal)?
SET? Main instrument parameters?
ID? Instrument identification code?
Maintenance functions
BAT? Battery status (BAT1 = OK, BAT0 = low battery)
OFF Switch-off (wake up using a button or RS)
RST Re-initialisation of the instrument
SBY Put instrument in stand-by (SIS)
VER? Version No. and date of firmware
14