Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
l.
Never lay the power tool down until the
accessory has come to a complete
stop. The spinning accessory may grab
the surface and pull the power tool out of
your control.
m. Do not run the power tool while
carrying it at your side. Accidental con‑
tact with the spinning accessory could
snag your clothing, pulling the accessory
into your body.
n.
Regularly clean the power tool's air
vents. The motor's fan will draw the dust
inside the housing and excessive accumu‑
lation of powdered metal may cause elec‑
trical hazards.
o.
Do not operate the power tool near
flammable materials. Sparks could ignite
these materials.
p.
Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocution
or shock.
FURTHER SAFETY INSTRUCTIONS FOR
ALL OPERATIONS
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush or
any other accessory. Pinching or snagging
causes rapid stalling of the rotating accessory
which in turn causes the uncontrolled power
tool to be forced in the direction opposite of
the accessory's rotation at the point of the
binding.
For example, if an abrasive wheel is snagged
or pinched by the workpiece, the edge of the
wheel that is entering into the pinch point can
dig into the surface of the material causing the
wheel to climb out or kick out. The wheel may
either jump toward or away from the operator,
depending on direction of the wheel's
movement at the point of pinching. Abrasive
wheels may also break under these conditions.
Kickback is the result of power tool misuse
and/or incorrect operating procedures or
conditions and can be avoided by taking
proper precautions as given below.
a.
Maintain a firm grip on the power tool
and position your body and arm to
allow you to resist kickback forces.
18
7062243_MaxxRoll_Ma_#1506-19.indb 18
Always use auxiliary handle, if
provided, for maximum control over
kickback or torque reaction during
start-up. The operator can control torque
reactions or kickback forces, if proper
precautions are taken.
b.
Never place your hand near the rotating
accessory. Accessory may kickback over
your hand.
c.
Do not position your body in the area
where power tool will move if kickback
occurs. Kickback will propel the tool in
direction opposite to the wheel's move‑
ment at the point of snagging.
d. Use special care when working
corners, sharp edges etc. Avoid
bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory
and cause loss of control or kickback.
e.
Do not attach a saw chain woodcarving
blade or toothed saw blade. Such
blades create frequent kickback and loss
of control.
ADDITIONAL SAFETY INSTRUCTIONS
FOR SANDING OPERATIONS
Safety Warnings Specific for Sanding
Operations:
a.
Do not use excessively oversized
sanding disc paper. Follow
manufacturers recommendations,
when selecting sanding paper. Larger
sanding paper extending beyond the
sanding pad presents a laceration hazard
and may cause snagging, tearing of the
disc or kickback.
ADDITIONAL SAFETY INSTRUCTIONS
FOR POLISHING OPERATIONS
Safety Warnings Specific for Polishing
Operations:
a.
Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings. Loose
and spinning attachment strings can
entangle your fingers or snag on the
workpiece.
08-09-15 11:05
Publicité
Table des Matières
