Remote Control Unit; Using The Remote Control Unit; Cautions When Using The Remote Control Unit; Loading Batteries Into The Remote Control Unit - Teac W-890RMKII Mode D'emploi

Remote Control Unit

i Tape transport control keys
RECORD (K) key
Pressing this key shifts the corresponding deck to record-pause
mode.
PAUSE (J) key
Pressing this key temporarily stops playback or recording.
Recording mute (REC MUTE) key
This key is for creating the 4-second blank space.
m/, key
Fast-forward/Rewind
STOP (H) key
Stop of playback/record.
PLAY (h / y) key
Reverse side play/Forward side play.
o Remote sensor
When operating the remote control unit, point it towards here.

Using the Remote Control Unit

Cautions when using the remote control unit

o Point the remote control unit at the remote sensor of the cassette
deck and operate the remote control unit at a distance of no more
than 5 meters. Do not place objects between the remote control
unit and remote sensor.
o Direct sunlight or very bright light will reduce the sensitivity of the
remote sensor. If this is the case, use the control buttons on the
cassette deck instead of the remote buttons.
o It is possible that other infrared-ray-sensitive equipment nearby
may malfunction when you operate the remote control.

Loading batteries into the remote control unit

Remove the lid of the battery compartment, load two "AA" sized
batteries in the indicated directions, and then replace the lid. When
inserting batteries, be sure to observe proper polarity (+ and −).
If you have to put the remote control unit quite close to the remote
sensor or if any remote buttons do not work, then the batteries are no
longer fit for use and must be replaced. Be sure to always replace both
batteries at once.
11